Hello,
I got a hybrid kit, 4 195w solar panels, connected in serie/parallel, and a 500w wind mill. I have 2 lifepo4 12v 100ah batteries connected in parallel.
I cannot figure out what parameters to use to get it to work, batteries never get charged and my controller has "error upv flashing". Is there anyone that could give me the parameters to put in my controller please.
U under
R under
U over
R over
MPPT
BCV
Float.
Thanks a lot
Eric
Hi Eric, which hybrid inverter is it? Pls give me your order number, I will ask my coworker to help you.
@Bryce Freeman
Hello Bryce, 800w solar wind kit order number: 701-3488947-9047416 sold by DC House
Solar panel order number: 111-1550506-1245022 sold by eco worthy us
Batteries order number: 111-9685691-6117004 sold by eco worthy us
When I connect my panels in parallel, the cables get to hot, so I connected 2 in serie than 2 in serie and than those in parallel. But now the controller always flashes "error Upv" and it gives over 30v.
At the beginning I had only the first two panels that came with the kit, and it charged but very little. I would make 2 coffees and batteries would be dead. So I thought I would add two more panels but it is worse, it does not charge at all.
Thanks for helping
Eric
????
@Eric Poirier Hi Eric, sorry, was too busy. I have copied your post to our customer service. You will receive message from Amazon soon. Make it resolved by professionals😀
How do you enter the parameters to my monitor
@Stuart Littlewood Could you tell me the order number of the monitor? You could refer to the manual to learn how to setup.
Probably not in the right place. Just joined, and finding my way around.
I am building my own DIY Battery pack, Ecoworthy Solar panel and MPPT 40 Amp controller
The system basically works, with One major problem, I can't get the Green LED output to stay on.
The output is switched by a remote relay, as it drives a small DC booster to the house from 11.1V 24V, for my interior lighting. The system functions as designed, but the controller Green LED times out if there is no load, so I have to activate it, either at the controller or from the APP.
All works again untill the load is removed, and the controller Green LED times out again, meaning I have to re-activate it every time I need power.
I have tried, times, and manual, but it always times out. Very frustrating.
David G1ZQC Lincolnshire.
